Community > Forum > Technology & Science > Heat shield simulation 4- hypersonic shock boundry layer

Heat shield simulation 4- hypersonic shock boundry layer

Posted by: Sigma - Fri Nov 30, 2012 12:29 am
Post new topic Reply to topic
 [ 2 posts ] 
Heat shield simulation 4- hypersonic shock boundry layer 
Author Message
Space Station Member
Space Station Member
User avatar
Joined: Mon Dec 12, 2011 6:40 am
Posts: 433
Location: California and Michigan
Post Heat shield simulation 4- hypersonic shock boundry layer   Posted on: Fri Nov 30, 2012 12:29 am
Heat shield hyper-sonic plasma accelerator test animations for eventually making a physically accurate model of a Hypersonic launch at sea level using the heat shield plasma as a reaction mass and some form of high energy density reactor or beamed power, to reach high orbit without any on-board propellant, the only non reusable section is the heat shield, after one exit/re-entry cycle

Plasma Shock wave simulation
Volumetrics Emission, Particle Fields
http://www.youtube.com/watch?v=wjkJ23QQoMA

_________________
Let not the bindings of society hold you back from improving it.... the masses follow where the bold explore.


Back to top
Profile
Space Station Commander
Space Station Commander
User avatar
Joined: Mon Dec 18, 2006 11:15 pm
Posts: 908
Location: Columbus, GA USA
Post Re: Heat shield simulation 4- hypersonic shock boundry layer   Posted on: Fri Nov 30, 2012 3:32 am
Couldn't really tell what I was looking at in the video. Is the simulation of the leading edge and so going "downward", gas pressures travelling upward against the plasma?


Back to top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 
 

Who is online 

Users browsing this forum: No registered users and 46 guests


© 2014 The International Space Fellowship, developed by Gabitasoft Interactive. All Rights Reserved.  Privacy Policy | Terms of Use